These forums are an Archive of the Live Forums at biodieseldiscussion.com on 11/26/2008.
These Archive Forums are read only. New registrations and posts are not allowed. To participate in live forums go Here
 



Go Back   Biodiesel & SVO Discussion Forums Archive - Live Forums at biodieseldiscussion.com > Straight Vegetable Oil (SVO) as Fuel > General SVO Discussion

General SVO Discussion Description

Reply
 
Thread Tools Display Modes
  #1  
Old 11-26-2008, 08:40 PM
The Gilead Garage The Gilead Garage is offline
Senior Member
 
Join Date: Oct 2003
Location: Randolph, VT
Posts: 107
Default

So I recently completely rebuilt a 1.6VW TD for my Samurai, installed it and all was well. Then I retorqed the Cyl head at around 500 mi (trying to be extra cautious) and ended up cracking the block! It's a very common crack - at #1 Cyl, side with oil drain. It did not hydrocrack either, the threads were clean.
So it's out and on the stand again, I have another block which I will get bored (1mm to fit my barely used pistons), Int shaft bearings and everything else when I get the dough.
To all VW IDI folks: Be careful when torquing those stupid stretch bolts! I'm going with head studs now, I have heard enough horror stories with the stretch bolts, and have now experienced this first hand.
Since it's all apart again, I'm rebuilding the trans (which needed worse than I thought) and am adding an oil pan baffle kit and high volume oil pump to the new motor.
Always something.
__________________
300TD
Samurai
Veggen
WVO shop heat
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 02:12 AM.


Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.